Analysis of Gold Concentration and Leaching Efficiency of PCB Waste Using Atomic Absorption Spectroscopy
DOI:
https://doi.org/10.47945/search.v4i2.3003Keywords:
Printed Circuit Board (PCB),, Pinted circuit board waste, Aqua regia leaching, HydrometallurgyAbstract
Printed circuit board (PCB) waste is a source of valuable metals with high potential for recycling, primarily because it contains relatively high concentrations of gold. This study aims to analyze the gold concentration in the filtrate obtained from leaching PCB waste using atomic absorption spectroscopy (AAS) and to evaluate the leaching efficiency achieved. The study began with sample characterization using Fire Assay and ICP-OES, followed by a pre-leaching process using 65% HNO₃ at 70°C for 60 minutes. The pre-leaching residue was then subjected to leaching using a mixture of 37% HCl and 65% HNO₃ in a 1:3 ratio at 70°C for 90 minutes. The leaching filtrate was analyzed using AAS after dilution: 1 mL of the solution was taken and diluted to 25 mL. The initial characterization results showed that the PCB sample contained 522 ppm of gold from 303.20 grams of PCB sample. AAS analysis revealed a gold concentration of 1.307 ppm in the diluted solution, equivalent to 81,69 ppm in the actual filtrate, with a leaching recovery rate of 34,44%. These results indicate that the leaching process was able to dissolve gold from the PCB matrix into the liquid phase. This study provides preliminary information on the potential for utilizing PCB waste as a source of secondary precious metals through hydrometallurgical methods and can serve as a basis for further research on leaching process optimization and gold recovery.
References
Arya, S., & Kumar, S. (2020). E-waste in India at a glance: Current trends, regulations, challenges and management strategies. Journal of Cleaner Production, 271, 122707. https://doi.org/10.1016/j.jclepro.2020.122707
Asworo, R. Y., & Widwiastuti, H. (2023). Pengaruh Ukuran Serbuk Simplisia dan Waktu Maserasi terhadap Aktivitas Antioksidan Ekstrak Kulit Sirsak. Indonesian Journal of Pharmaceutical Education, 3(2). https://doi.org/10.37311/ijpe.v3i2.19906
Celep, O., Yazici, E. Y., & Deveci, H. (2017). A Preliminary Study on Nitric Acid Pre-treatment of Refractory Gold/Silver Ores.
Das, D., Mukherjee, S., & Chaudhuri, M. G. (2021). Studies on leaching characteristics of electronic waste for metal recovery using inorganic and organic acids and base. Waste Management & Research: The Journal for a Sustainable Circular Economy, 39(2), 242–249. https://doi.org/10.1177/0734242X20931929
Forti, V., Baldé, C., Kuehr, R., & Bel, G. (2020). The global E-waste monitor .... 2020. https://ewastemonitor.info/wp-content/uploads/2020/11/GEM_2020_def_july1_low.pdf
Golmohammadzadeh, R., Faraji, F., Jong, B., Pozo-Gonzalo, C., & Banerjee, P. C. (2022). Current challenges and future opportunities toward recycling of spent lithium-ion batteries. Renewable and Sustainable Energy Reviews, 159, 112202. https://doi.org/10.1016/j.rser.2022.112202
Huang, Y.-F., Chou, S.-L., & Lo, S.-L. (2022). Gold recovery from waste printed circuit boards of mobile phones by using microwave pyrolysis and hydrometallurgical methods. Sustainable Environment Research, 32(1), 6. https://doi.org/10.1186/s42834-022-00118-x
ITU, & UNITAR. (2024). The Global E-waste Monitor 2024. ITU. https://www.itu.int/en/ITU-D/Environment/Pages/Publications/The-Global-E-waste-Monitor-2024.aspx
Jia, L., Huang, J., Ma, Z., Liu, X., Chen, X., Li, J., He, L., & Zhao, Z. (2020). Research and development trends of hydrometallurgy: An overview based on Hydrometallurgy literature from 1975 to 2019. Transactions of Nonferrous Metals Society of China, 30(11), 3147–3160. https://doi.org/10.1016/S1003-6326(20)65450-4
Kumar, A., Holuszko, M. E., & Janke, T. (2018). Characterization of the non-metal fraction of the processed waste printed circuit boards. Waste Management, 75, 94–102. https://doi.org/10.1016/j.wasman.2018.02.010
Li, J., Duan, H., Yu, K., Liu, L., & Wang, S. (2010). Characteristic of low-temperature pyrolysis of printed circuit boards subjected to various atmosphere. Resources, Conservation and Recycling, 54(11), 810–815. https://doi.org/10.1016/j.resconrec.2009.12.011
M Ilham, Nurhawaisyah, S. R., & Bakri, S. (2023). ANALISIS WAKTU PELINDIAN TERHADAP PELARUTAN LOGAM Au DALAM BIJIH EMAS DENGAN PROSES HIDROMETALURGI. Jurnal Aneka Tambang, 1(2), 43–47. https://doi.org/10.33096/jat.v1i2.347
Mingkasari, M., Najia, R. S., Pambudi, R. I., Primaswari, C. S., Saputri, I. D., Salma, D. A., & Salsabila, V. S. (2025). Tinjauan Sistematis Peningkatan Kelarutan Sampel dalam Analisis Spektrofotometri Serapan Atom (SSA) pada Matriks Kompleks: Studi Literatur 2015–2025.
Muhammad, I., Triantoro, A., & Novianti, Y. S. (2020). Optimasi Kondisi Pelarutan Logam Au Dalam Endapan Placer Dengan Proses Hidrometalurgi. Jurnal Geomine, 7(3), 162. https://doi.org/10.33536/jg.v7i3.465
Ormuž, J. K., Žmak, I., & Ćurković, L. (2026). Selective Gold Recovery from Waste Electronics: A Speciation-Based Recycling Approach. Materials, 19(3), 538. https://doi.org/10.3390/ma19030538
Ouro-Salim, O. (2024). Urban mining of e-waste management globally: Literature review. Cleaner Waste Systems, 9, 100162. https://doi.org/10.1016/j.clwas.2024.100162
Putri, R. R. D. A., Pangestu, D., & Khairunnisa, D. C. (2022). Pengaruh Variabel Solvent dan Waktu Leaching terhadap Konsentrasi Emas Terlarut pada PCB Handphone. Fluida, 15(1), 30–37. https://doi.org/10.35313/fluida.v15i1.3458
Rao, M. D., Singh, K. K., Morrison, C. A., & Love, J. B. (2020). Challenges and opportunities in the recovery of gold from electronic waste. RSC Advances, 10(8), 4300–4309. https://doi.org/10.1039/C9RA07607G
Rodrigues, C. F., Blaga, L., & Klusemann, B. (2023). Friction riveting of FR4 substrates for printed circuit boards: Influence of process parameters on process temperature development and joint properties. Journal of Materials Research and Technology, 24, 4639–4649. https://doi.org/10.1016/j.jmrt.2023.04.092
Rofika, F., & R., T. A. (2018). PROSES HIDROMETALURGI MENGGUNAKAN PELARUT AQUA REGIA PADA RECOVERY LOGAM EMAS (Au) LIMBAH ELEKTRONIK PCB HP. JURNAL ENVIROTEK, 9(1). https://doi.org/10.33005/envirotek.v9i1.1045
Sheng, P. P., & Etsell, T. H. (2007). Recovery of gold from computer circuit board scrap using aqua regia. Waste Management & Research: The Journal for a Sustainable Circular Economy, 25(4), 380–383. https://doi.org/10.1177/0734242X07076946
Tyassena, F. Y. P., Prameswara, G., & Suherman, A. F. (2023). Studi Pengaruh Konsentrasi Solvent Dan Kondisi Operasi Terhadap Persen (%) Recovery Nikel Pada Proses Atmospheric Leaching Ore Laterite Asal Morowali Dengan Asam Sulfat. Journal of Chemical Process Engineering, 8(1), 49–54. https://doi.org/10.33536/jcpe.v8i1.1761
Van Yken, J., Boxall, N. J., Cheng, K. Y., Nikoloski, A. N., Moheimani, N. R., & Kaksonen, A. H. (2021). E-Waste Recycling and Resource Recovery: A Review on Technologies, Barriers and Enablers with a Focus on Oceania. Metals, 11(8), 1313. https://doi.org/10.3390/met11081313
Laboratorium IPA Terpadu, Km. 17, Klablim, Kota Sorong - PBD
searchjpipa@gmail.com
